Set additional parameters

If you've set a driving or public transport route, you can configure it using additional criteria.

For this, in the side menu, click Parameters and select options.

Driving route

Ignore current traffic conditions — If this option is enabled, route options are set ignoring traffic conditions.
Avoid toll roads — If this option is enabled, toll roads are not included in the route.

When the option is disabled, the route may pass through toll roads ( marked by the icon on the map). If the cost of travel is known, you'll see the cost of the entire route for a passenger car.
Truck parameters — To build a route taking into account the physical and regulatory restrictions along the road, enter the data:
- Actual (laden) weight, maximum authorized mass, axle load, load capacity limit (in metric tons).
- Height, width, and length (in meters).
- Emission standard — Select a relevant value (from Euro-1 to Euro-6).
- Trailer truck — Enable this option if you use a trailer.
If the route can't accommodate all specified parameters, you'll see a warning saying Not all truck parameters were used for routing in the route card. To edit the data, click on the warning message.
Departure time and date — Select the intended day and time of your travel. The route will be built according to the parameters you specified.

To reset the parameters, click Now.

Transport preferences — Select the type of transport you are going to use. If matching routes exist, they will be shown both in the side menu and on the map.
Departure time and date — Select the intended day and time of your travel. The route will be built according to the parameters you specified.

To reset the parameters, click Now.