Uploading and updating the RSS feed

Uploading

Attention

You can add up to 100 sources in total for all hosts that are located on the same second-level domain.

To upload the RSS file:

  1. Host the generated RSS feed on your server. It must be available via a link, like https://example.com/rss-feed.xml.

  2. Allow the Yandex.Webmaster robot to index the RSS feed using the Allow directive in the robots.txt file.

  3. In Yandex.Webmaster, go to Turbo pages for content sites → Data sources.

  4. In the Attribution block, choose the RSS for content sites option.

  5. Specify the link to the RSS and click Add. You can add up to 100 RSS files in total for all hosts that are located on the same second-level domain.

    Note

    The download and verification takes place within 24 hours.

  6. If you use authorization to access the RSS feed, on the Turbo pages for content sites → Settings → Access page, enter your username and password.

After uploading, you can turn on the display of Turbo pages and launch the quick RSS feed check. For details, see Managing Turbo pages display.

Updating

Attention

When the RSS feed is updated, the source status may change. For example, errors may be detected in the file. Information about it is displayed in Yandex.Webmaster. To receive messages by email, configure notifications.

To update the Turbo page content, make changes to the RSS feed on your site's server. The Yandex robot downloads a file every hour.

Note

The file must be accessible via the HTTP or HTTPS protocol. If a robot could not download it within 10 seconds, the file is considered unavailable. In this case, the Turbo pages for content sites → Diagnostics page in Yandex.Webmaster will show a "Loading error".

To disable automatic RSS feed checking and updating:

  1. In Yandex.Webmaster, go to Turbo pages for content sites → Data sources.

  2. Set the radio button next to the desired source to Off. The Turbo page will still be included in Yandex search. To turn off its display, edit the RSS feed.

  3. To recheck the source manually, click Recheck. The robot will check the correctness of the first 10 elements of the file.

To turn on automatic checking and updating of the RSS feed, set the radio button to On.

Contact support
Previous
Restrictions
Next
Common RSS feed errors